Deduction of operating Tutorials

Deduction of operating Tutorials
1 sample with a ruler to measure the length of the hose
2 metal joints using a caliper measurement data , the sample was observed inside diameter hose
3 Prepare hoses and fittings needed
4 with a cutting hydraulic hose ends to cut the required length of the hose , the hose bore cleaning
5 skiving machine with outer rubber hose stripped , and then insert a metal hose connector sleeve.
Note: You must peel off the outer layer of rubber hose
6 straight pin plug connector metal hose directly to the bottom
7 . Measuring hose and hose samples are the same length
8 shrink tube with no taper reusable hose fittings
9 The transfer hose will be withheld by the provisions of the Data Locator quasi
10. Began to withhold hose, you can use the manual button or using the foot withhold withhold button
11 hose crimping in place , you can locate the alarm sounds , and then press the button to open the mold
12. Withhold withhold data caliper measurement is completed , using probes to detect
13 hose to the required data can be withheld
14 Withhold completed