cutting machine operating procedures
A cutting preparation
(A), must be carefully checked before using the device's performance, to ensure the integrity of the various components.
(Two), power knife switch, saw the tightness of the blade guard or safety baffles detailed examination, console must be stable, night work should be sufficient
Illumination.
(Three), before use, first open the master switch, load test turn laps, to be confirmed safe and correct before allowed to start.
(Four), the operator must check before power is conventional with the power tool matches the voltage rating 220VA, 380VA received in order to avoid the wrong power source.
Second, cutting considerations
(A), cutting machines are doing and not only to keep a clear head, but also to rational operating a power tool. Prohibited tired, drunk or taking excitement
, Drugs operate after cutting.
(Two), the power supply lines must be safe and reliable, is strictly prohibited without permission Luanla, carefully place the power cord, do not be cut off. Must be carefully checked before using the equipment performance, indeed
Paul parts intact.
(Three), wear appropriate clothing,
| hydraulic ferrule fittings do not wear loose clothing, not wearing jewelry or long hair, is strictly prohibited without wearing gloves and cuff buckle and operation. |
(Four), the processing of the workpiece must be clamped firmly prohibited workpiece clamping is not tight to start cutting.
(Five), is prohibited in the wheel plane workpiece grinding burr grinding wheel to prevent fragmentation.
(Six), the operator must deviate cutting grinding wheel front and goggles.
(Seven), prohibited the use of already crippled grinding wheel, cutting should be to prevent Mars scattered and away from flammable materials.
(Eight), clamping the workpiece should be stable and secure clamping, shields must be installed correctly, after clamping air operation should start checking, without vibration and abnormal noise.
(Nine), halfway replaced with new cutting disc or grinding wheel piece, do not tighten the nut with excessive force, preventing blade or grinding wheel crack accidents.
(Ten), must be stable grip cutter handle evenly vertical incision, and the fixed end to be solid and reliable.
(Eleven), shall not attempt to cut saws unclamped small workpiece or with a serious edge profiles.
(Twelve), in order to improve work efficiency. Together for single or multi-branch sawing, be sure to do a good job supporting fixture positioning.
(Thirteen), shall not carry powerful sawing operation, before cutting to reach full speed until the motor speed can be.
(Fourteen), allow anyone to stand behind saws, power failure, rest or leave the work place, immediately turn off the power.
| hydraulic coupling (Fifteen), the blade may not stop on the workpiece from a saw or a hand or loosen any lift arm. |
(Sixteen), shall not be operated when the guard is not in place, can not put your hands away from the blade 15 cm or less. Not lean over or bypassing saw, when operating body 45 degrees Xiece
Appropriate.
(Seventeen), appear to have unusual sounds, immediately stop checking; repair or replacement of parts must be cut off before the power and other blade has completely stopped.
(Eighteen), the use of cutting machine, such as when working in wet places, must stand on dry insulating mats or on the board. Ascend or explosion and other hazardous areas must
Should take the safety precautions.
| hydraulic ferrule (Nineteen), shakes and other equipment failures, should immediately stop repair, prohibited ill and taking stimulants and drink operations, operations are forbidden to wear gloves. |
If during operation will cause dust, wear a mask or face shield.
(Twenty) process should be finished off, and make cleaning equipment and surrounding venues.
